 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sohc Honda CB Motorcycles |
|||||||||||||||||
 |
|||||||||||||||||
 |
|||||||||||||||||
| Place the speedo face and trip shaft back in and re-tighten counterclockwise (remember the reverse thread). Put the tow screws in the back a few turns, but don't tighten. Then slip about an inch and a half of the back's lip edge (at the trip-set shaft) into the retaining ring and use the utility knife to work it into the retaining ring all the way around. Fully tighten the screws in the back and gently center the trip shaft in its whole by rotating the back. | |||||||||||||||||
 |
 |
||||||||||||||||
| In order to close or re-crimp the retaining ring, you can use thin leather or sturdy clothe in between the pliers, but don't just squeeze the pliers. Apply the pressure from the top teeth by pushing the bottom teeth inward toward the speedo and lifting the pliers' handles upward as indicated by the arrows (right). | |||||||||||||||||
 |
|||||||||||||||||
|
Consider lubing the cable and put that sucker back on the bike !! |
|||||||||||||||||
| Previous Page 1 - 2 - 3 - 4 - 5 | |||||||||||||||||
