Adjusting and installing the Jet Needles - Kei Hin Carburetor

    The clip position by manufacturers spec is in the middle notch, but before going any further, read THIS to help you understand how and where to adjust the jet needle clip (shown above left).  The Jet Needle lies in a hole below (protruding downward) the adjusting rod mounting plate seen in the photo above right.  Sorry - I was getting impatient and didn't photograph this.

 

Carefully insert each slider into its original carburetor, minding that the "jet needle" goes into the "needle jet" smoothly.  Notice the groove in the slider, it will match a tab inside the carb.

Previous - Next (Page)                           If you came from an outside link Click HERE